Simulate and Build RF and Microwave devices

The projects whatever we do in Undergraduate, Postgraduate can be funded by MTT Society,APS and IEEE.To get the funding our project idea must be efficient and good.

Basics of RF System Design
Mixer - Multiplies two input signal to provide an output signal.
Power amplifier-Optimize output power and power efficiency.

RF Transmitter and TX Receiver consist of 
1) Mixer 
2) Branch Line 
3) Local Oscillator 
4) Power amplifier 
5) Antenna

Microwave Patch Antenna:
      (i) RT5880 is a substrate with low dielectric constant of 2.2,Thickness of 1.6mm,Loss target of 0.0009 at 2.4GHz
     (ii)Wlan applications 


At lower frequency -  penetration higher - Size huge - Speed lesser

At higher frequency - Penetration lower - Size small - Higher speed.

For 5g below 6GHZ

3.5GHZ - Massive mimo
Above 6 GHZ - Millimeter.


Comments

Post a Comment

Popular posts from this blog

UART TRANSFER BETWEEN TWO ARDUINO UNO R3

Image
  void setup() {   // set push button pin as input   pinMode(8, INPUT_PULLUP);    pinMode(13, OUTPUT);         digitalWrite(13, LOW);       Serial.begin(9600);        } void loop() {   if (Serial.available()) {     // read one byte from serial buffer and save to data_rcvd     char data_rcvd = Serial.read();           if (data_rcvd == '1') {        digitalWrite(13, HIGH);      }     if (data_rcvd == '0') {      digitalWrite(13, LOW);  // switch LED Off     }   }  if (digitalRead(8) == HIGH) {      // send the char '0' to serial if button is not      pressed.      Serial.write('0');   }       else {      // send the char '1' to serial if button is pressed.     Serial.wr...
Read more

Go Back N ARQ

 #include <stdio.h> int main() {     int length=10;     int sender[]={1,0,2,8,4,8,9,6,3,4};     int receiver[length];     int ws=4;     int base=0;     while(base<length)     {         printf("Frame transmitted");         for(int i=base;i<base+5;i++)         {             receiver[i]=sender[i];             if(sender[i]==receiver[i])             {                 printf("%d\n",receiver[i]);             }             else             {                 printf("Not transmitted frame");             }         }         base+...
Read more