POSITIVE LOGIC




 // C++ code

//

void setup()

{

  pinMode(2,INPUT);

  pinMode(3,OUTPUT);

}


void loop()

{

  int x=digitalRead(2);

  if(x==HIGH)

  {

    digitalWrite(3,HIGH);

}

  else

  {

    digitalWrite(3,LOW);

  }

}

Comments

Post a Comment

Popular posts from this blog

UART TRANSFER BETWEEN TWO ARDUINO UNO R3

Image
  void setup() {   // set push button pin as input   pinMode(8, INPUT_PULLUP);    pinMode(13, OUTPUT);         digitalWrite(13, LOW);       Serial.begin(9600);        } void loop() {   if (Serial.available()) {     // read one byte from serial buffer and save to data_rcvd     char data_rcvd = Serial.read();           if (data_rcvd == '1') {        digitalWrite(13, HIGH);      }     if (data_rcvd == '0') {      digitalWrite(13, LOW);  // switch LED Off     }   }  if (digitalRead(8) == HIGH) {      // send the char '0' to serial if button is not      pressed.      Serial.write('0');   }       else {      // send the char '1' to serial if button is pressed.     Serial.wr...
Read more

Go Back N ARQ

 #include <stdio.h> int main() {     int length=10;     int sender[]={1,0,2,8,4,8,9,6,3,4};     int receiver[length];     int ws=4;     int base=0;     while(base<length)     {         printf("Frame transmitted");         for(int i=base;i<base+5;i++)         {             receiver[i]=sender[i];             if(sender[i]==receiver[i])             {                 printf("%d\n",receiver[i]);             }             else             {                 printf("Not transmitted frame");             }         }         base+...
Read more